Friday, April 8, 2011

Hmmmm......

New main shaft support doesn't fit on this Revtech tranny....The holes didn't line up
with the studs so I opened them up a bit, still a little tight but got it on and the bearing bottoms out on the sprocket nut. Smashed the seal. As you can see the support plate still had a ways to go before being flush with the tranny case...Love this kind of shit, Happy Fuckin Friday!!!







2 comments:

  1. Gotta make spacers...it happens with Bakers too. You'd think someone would make a decent bearing support.

    ReplyDelete
  2. Figured as much....sum boo shit RAY!

    ReplyDelete